Go to your register tab in wireless to see the signal strength of each associated client. What signal do you want? AP usually has several stations connected, so how does AP knows which signal to show? So it is useless feature and thus probably not available in software. the VOLTAGE MONITOR witch is WHAT every one who runs a solar site NEEDS!.not to forget the beeper witch plays mario theme on startupĪnd no one knows this? How to make the ap to show signal leds?Īnd no one knows this? How to make the ap to show signal leds?Well, probably because it is in AP mode. Operating system MikroTik RouterOS v5, Level4 license (AP, station or point-to-point) Package contains Groove A-2Hn unit, mounting loops, PoE injector, 24V power adapter RX sensitivity 802.11b/g: 92 dBm 6Mbps to -75 dBm 54 Mbps 802.11n: 92 dBm MCS0 to -71 dBm MCS7 40MHz TX power 802. and not to mention the runing software with is 10000000 years more advanced than the AirOS witch comes to ubiquiti. it is more cheap than the bullet m5hp witch comes with none of those. PS: I really like the groove so far, comes with power adapter 24v 0.8Ah, poe injector and 2 plastic strips, and yes. Advanced version of Nstreme, called Nstreme2 works with a pair of wireless cards - one for transmitting data and one for receiving. the LEDs on AP will stay on in this mode. The Nstreme protocol is MikroTik wireless protocol aimed to improve point-to-point and point-to-multipoint wireless links. but the leds than stay ON all the time regarding the signal strenght.even if I turn off the STA. Hi there, does anyone knows how to make the groove AP to show signal LEDS?, The Groove is our smallest outdoor series model - a fully featured RouterBOARD powered by.

Mikrotik groove